Breeding Corydoras
by Eric Naus
of Amsterdam Holland, from his website: www.aquaworld.biz/catalog
Aquarticles
When one is trying to breed Corydoras, a special breeding tank will usually give better
results than waiting for them to spawn in the community tank. Even if they do spawn in the
community tank, it is very likely you will not notice it at all. The eggs are well hidden
by the fish, and even if the eggs survive the hungry attentions of the co-inhabitants of
the tank and the parents themselves, the larvae coming out of the egg are extremely
vulnerable. The first thing they have to do when emerging from the egg is to go up for air
to fill the swim bladder. Still, some may occasionally survive this, and after a month or
three the owner will be in for a surprise when the first 2 cm long juvenile calmly cruises
the tank for food.
Let's assume you plan to breed a particular species of Corydoras. The general tank
setup will be described below.
The following information is not a must, but are things that have worked for me, or
which I've read. By no means expect your fish to start breeding immediately, even after
you've invested a lot of money to copy the described tanks, materials and fish.
The tank
A Corydoras breeding tank should be long enough. As a rule of thumb, length of the tank
should be at least ten times the maximum size of the adult fish. There have been numerous
reports about full grown paleatus spawning in a 30cm. tank or even smaller, but
of course no-one reports the failures. Take it from me that the bigger the tank, the
higher the success rate.
Height of the tank should not exceed 30cm. (The tank could be higher, but then simply
do not fill it up over this height).
The fish
This is one of the most important issues, although it's hardly ever mentioned in any
set-up information. Of course the fish have to be healthy. And yes they should be fed
well. But that is about all that is mentioned.
First things first. A group of fish should be selected, and they should be mature
enough. The best way is of course to buy full-grown wild-caught fish. If you buy
wild-caught fish, the first thing to do is to make sure they are disease free. During
transportation the fish are usually treated really badly. Some medications used on fish
will render them temporarily infertile, which is one of the reasons why so many first
spawns go bad. (Although some people theoretisize this to be a learning process for the
fish - nicely thought of by humans, but in free-laying species there is no feedback to the
parents that the eggs are not fertilised, so how could they learn?)
Large fish (the ones we want) are usually more expensive because of the higher death
rate during shipping (lower water to bodyweight ratio) and because the shop owners know.
Do not believe shop owners, they will try to get as much profit from sales as possible.
Prices tend to skyrocket for the people they know will buy this or that new or rare cory.
Send your friends, and jeez, half price for them. Basically it's whatever the fool will
give, they will charge.
Do not under any circumstance buy only three fish because they are expensive, and
another three in a month's time. There is no guarantee they will be the same species, or
type locality.
Small fish will also grow big, although for most species it takes a minimum of two to
three years to reach a reasonable size, and growth rate is reduced in tanks when compared
to nature.
The decor
If you'd like a nice looking tank, you are not going to like this part. Don't worry, the
fish tend to breed in those as well. Hiding places: one will suffice - a coconut
shell, or better yet create a cave with multiple exits by placing a flat stone on some
smaller stones. Plants are optional, but not essential.
The lighting
Twelve to thirteen hours of light, preferably subdued light, or no light at all if the
tank is near a window.
The substrate
Should be sand, approx. 0.5-1cm. layer.
The filtration
Strong filtration, especially in one area of the tank. But there should be areas where
there is little or no current, so the fish can rest.
The temperature
24-26ēC.
Water changes
Daily 50% water changes with pre-treated water, approximately 5-10ēC colder than the
water in the tank. Be careful when changing the water - if a part of the glass is directly
exposed to 10ēC colder water, it may break!
Feeding
Feed the fish well, as much as they like and more. (You're doing daily water changes, so
any left overs are no problem). Feed them with red mosquito larvae (bloodworms), daphnia,
artemia, chopped earthworm and tubifex.
If you keep this up for a week or two (or longer) most Corydoras will spawn. Some
require more attention, and should be kept in soft, acidic water for a while. Then change
the water with soft, neutral water, to get both a rise in pH and a drop in temperature.
Eggs
Be very careful when handling the eggs. The best thing to use is spawning mops, which will
enable you to remove the eggs from the tank without handling them. Place the eggs in water
taken from the spawning tank into a small holding tank. Still, many eggs may fungus, and
most of the times the fish have a mind of their own as to where the eggs should be laid.
If you have to remove the eggs by hand, wash your hands thoroughly before removing the
eggs (making sure that no soap remains on your fingers). Some people use a razor blade to
remove eggs from the glass, but I've never been able to do that right. Corydoras eggs are
extremely hard, and you cannot squash them by handling them.
Back to the eggs fungusing. Eggs fungus as a result of bacterial attacks, which results
in the shells being damaged. The fungus is the second infection, because it attacks
damaged eggs. Most of the times that I tried to raise the eggs in a separate raising tank,
60-80% of the eggs fungused. Adding a preventive medicine like methylene blue helped a bit
to increase hatch rates.
Later I started using breeding nets, which hung from the side of spawning tank. Hatch
rates raised to around 90-95%. I keep the fry there, feeding them artemia, for a week or
two, and then I transfer them to a raising tank.
Using a pure glass bottom in a raising tank may seem to be a good thing to do, since
it's easy to clean. But in my case the fry often developed fungus. In a glass-bottom tank
a thin layer of bacteria will always be present, which may cause this. After I added a
thin layer of sand, the fry stopped developing fungus.
It's a really nice sight, having an 80 cm tank filled with over 100 juvenile Corydoras
(in my case panda). You can observe some natural schooling behaviour, and watch them eat
and grow. They can grow quite fast up to 2-3 cm. (depending on the species), but after
that growth comes to a halt, and it may take up to a year before the fry are the same size
as the juveniles you mostly see in the shops. It will take at least a year more for them
to become fully grown.
|